Urban XC Trail E-Bike (EN06) E-bike Display Panel - 16 Hidden Settings

Описание

Buy the latest and greatest e-bikes now over on our Amazon page: https://geni.us/iQsHd5

Also do check out our website for the latest UK E-bike news, reviews and videos - https://www.eb-uk.co.uk/

________________________________________________

#ebikes #ebike #ebiking
________________________________________________

To access these turn LED display on, then hold both "-" & "+" buttons at the same time.

Setting 1 (P01): This adjusts the brightness of the display and there are 3 levels (1: darkest; 3: brightest)

Setting 2 (P02): This switches between KPM and MPH if you need it. (0: KM; 1: MILE)

Setting 3 (P03): This setting allows you to adjust the power voltage from 24V, 36V to 48V

Setting 4 (P04): This setting allows you to adjust the auto-sleep timer and it goes up in minutes - 0 means no auto sleep.

Setting 5 (P05): This is an interesting setting, it allows you to set the levels of peddle assist to 0-3, 0-5, 0-3, 1 - 3, 1-5 and 1-9

Setting 6 (P06): This allows you to adjust the power to suit your wheel's diameter. By making this bigger than the diameter of the wheel will make the bike go faster and enter it less than the diameter of the wheel will make the power of assist slower.

Setting 7 (P07): Magnet Steel Number (for Speed Test) Range: 1-100 - This is normally 47 for direct drive (1200w and above) motors and 01 for geared (250w - 750W) motors.

Setting 8 (P08): This is the setting most people will be interested with. This controls your max speed. Using "-" & "+" buttons to make the bike go slower or faster - remember UK law states it can only go 25 KPH (15.5 MPH), this setting is set in KPH, with a max of 35 KPH (22 MPH) Range: 0-50km/h, parameter 50 indicates no speed limit, but it goes no faster than 35 KPH (22 MPH) anyway

Setting 9 (P09): Direct Start / Kick-to-Start Setting (0: Direct Start or 1: Kick-to-Start)

Setting 10 (P10): Drive Mode Setting

0: Power Assist – The specific gear of the assist drive decides the assist power value. In this status, the handlebar does not work.

1: Throttle Mode – The vehicle is driven by the handlebar. In this status the power gear does not work.

2: Power Assist + Throttle – Electric drive does not work in zero-start status.

Setting 11 (P11): This adjusts the sensitivity of your pedal assist. the higher the number the more sensitive it will be, the lower the number the longer it will wait to kick the power in.

Setting 12 (P12): Power Assist Intensity Range: 0-5 - 0=soft torque and 5= kick arse torque

Setting 13 (P13): Power Magnet Steel Number 5 / 8 / 12pcs - magnets in PAS Sensor Disk. There are 3 types: 5, 8, and 12. Dots on the magnetic ring. It’s 8 as default (Set it as 12 in case you have 12 magnet rotors).

Setting 14 (P14): Current AMPS Limit Value: 12A by default; Range: 1-20A

Setting 15 (P15): Low Voltage Cut-Off: Powers everything off at set voltage to prevent damage

Setting 16 (P16): ODO Zero-Out, distance travelled measurement (the Odometer Record) Long press the up key for 5 seconds and ODO value will be erased.