How to build your own octocopter, frame build and electonics fitting.

Описание

Note that EVERYTHING you need can be bought from hobbyking.com simply search for the items described below

http://www.instructables.com/id/How-to-build-a-Multirotor/
full tutorial


All required parts are listed below
hobbking x930 frame
8 x 30Amp esc's any make or brand, just make sure they are 30Amp not 25 with 30burst.
30 bullet connector pairs 2.5mill or higher.
20pais of xt60 battery cnnectors
8 meters of silicone wire- 4 meters red - 4 meters black 26swg which is 3mm thick or more.
solder- preferred leaded.
8 x 12x4.7 props 4 clockwise 4 counter clockwise (order spares!)
8 x 850/750/700 kv outrunner motors bell type
lots of various sized shrink tubing.

(Radio)
Turnigy 9xr
Frysky Jr module with telemetry RX
2 x frsky voltmeters (note i am referring to small meters that are less than $5 each they have a red and black wire coming off each end with a servo plug on one end)

Male to male servo plugs x 18
Male to female extension leads (any length) x 10
stickyback velcro


Above is everything you need to build your own copter.




4x 2200MAH 3s battery or any 2 battery combination that totals at least 8000MAH
APM 2.5 flight controller board
MAvlink for telemetry (not required)
Ublox GPS