Langmuir systems "No RnR motion controller found" Mach3

Описание

In this video I demo my schematic upgrade for the 5v isolation and Estop. These mods improve the stability of the motion controller and software for the Langmuir systems crossfire.
This mod can be made on the original crossfire setup, all you need is a 5v power supply with .5 amps or more. Just remove the part shown in the drawing and connect the 5v between the 5v terminal and ground on the motion controller board. No need to change anything else, the original
"torch on" relay uses 5 volts. This may let you use plasma cutters that would normally freeze the
software when the torch is fired.
Original video: https://youtu.be/aBS1jvWg8Sk
Parts list: https://youtu.be/PbCzDdS9LeA
Walk Around: https://youtu.be/_Oj05SrXc3Y
Wiring Diagram: https://youtu.be/ih49BJmP0CY
High Speed Cut: https://youtu.be/2t7urPIclLQ
Ports and Pins Tutorial: https://youtu.be/TmLIcV9G_Bc
Probe setup tutorial: https://youtu.be/BnGWuX9zX0Q
Machine tips: https://youtu.be/nkXThVPKC24
Z axis Calibration: https://youtu.be/1oieRp1poBw
Hand torch version: https://youtu.be/-TvacA6H2PU
3D printed sensor holder demo: https://youtu.be/NIuabaS6WCU
Jog control for $10: https://youtu.be/pDAOGwtNJE4
Proma 150SD Tutorial: https://youtu.be/Ao58zvExKSk
Upgraded probe sensors: https://youtu.be/9HZsRRleJug